About product: White cement-based, chemically enriched dry facade mixture is made of ordinary bricks and stones, concrete blocks, etc. Used for smoothing and decorating woven exterior surfaces. Dekostone plaster is easy to prepare, has high adhesion to the surface and high strength after hardening. The presence of special hydrophobic and polymer additives in the mixture increases the resistance of the coating to water and vibrations of various origins. Meets the requirements of AZS 039-2000 standard.

Intended use: XPS, EPS, mineral wool and cement are used to create a decorative look on the facades and interiors of buildings.

Advantages:

• The dry mixture can be prepared in a wide range of colors

• Gives architects and designers a wide range of imagination

• The speed of work increases by 2-3 times

• Water absorption is reduced by 1.5 times

• The strength limit in bending and compression is doubled.

Surface preparation: The surface should be cleaned of dust, dirt, oil, bitumen stains and paint coating. The strength of the surface should be checked and, if necessary, repaired. The surface should be washed with a binder or water 24 hours before to improve adhesion.

Application: Add 1.4-1.8 liters of water to 10 kg of DEKOSTONE product and wait for a few minutes, then mix mechanically or by hand until a homogeneous mass is formed. The dry mixture can be injected to a thickness of 5-20 mm.

Note: Make sure that the water, utensils and tools used are clean.

Storage conditions and durations: The product can be stored for 6 months in a dry and clean place, without touching the floor, on wooden or similar pallets, stacking a maximum of 10 pieces on top of each other.

Warnings: “Fortis Group” LLC is not responsible for any problems that may occur during use outside of these instructions.