About product: Izobar is a semi-elastic waterproofing material with two components (A Component powder, B Component liquid) based on polymer dispersion. Meets the requirements of AZS 039-2000 standard.

Intended use:

• indoors and outdoors, on vertical and horizontal surfaces

• on dam walls

• in large reservoirs (also for drinking water)

• in all sensations of the building exposed to moisture, such as toilets, bathrooms, kitchens and balconies

• in swimming pools

• on terraces

• in foundation and retaining walls.

Surface preparation: The surface must be dry and firm, free from dust, dirt, foreign bodies and all residues that prevent adhesion. The surface should be washed with a binder or water 24 hours before to improve adhesion. Uneven surfaces should be repaired in advance.

Preparation of the product: “Izobar” is packaged in a ready-mixed ratio. The material is added to the liquid in a clean container and mixed with a mixer for 400-600 rpm for 3-5 minutes until a homogeneous and pellet-free mixture is obtained. After 3-5 minutes and mixing again for 30 seconds, it is ready for use. The material is applied in 2 or 3 coats on a pre-moistened surface. It is important to wait for the substrate to dry before applying each layer. The waiting time between layers should not be less than 5 hours. The layers should be applied perpendicular to each other.

Note: Make sure that the water, utensils and tools used are clean..

Storage conditions and durations: Product in a dry and clean place,can be stored for 12 months by stacking a maximum of 10 pieces on wooden or similar pallets, provided they do not touch the floor.

Warnings: “Fortis Group” LLC is not responsible for any problems that may occur during use outside of these instructions.