About product: Used for mosaics, bonding ceramics, natural stone and other facing materials, it is a high-quality, water, frost and heat resistant universal adhesive that can be used indoors and outdoors (facades). Meets the requirements of AZS 039-2000 standard.

Intended use:

• exterior (facade) and indoors

• in bathrooms, toilets and kitchens

• in swimming pools, reservoirs, balconies and terraces

• It is used for gluing facing materials on surfaces such as concrete, plaster, floor plaster.

Surface preparation: The surface must be cleaned of dust, dirt, oil, bitumen stains and paint. The strength of the surface should be checked and, if necessary, repaired. The surface should be washed with binder or water 24 hours before in order to improve adhesion.

Note: Make sure that the water, utensils and tools used are clean.

Preparation of the mixture: Pour 5-6 lt of water into a clean mixing vessel, add 1 bag of the adhesive slowly, wait for several minutes, and mix manually or using a proper mechanical mixer until a lump-free homogeneous mixture is achieved. Mix again after 5-6 minutes. The ready mixture should be used within 120 minutes.

Instructions for use of the mixture: Apply the mixture on the prepared surface (thickness: 2-15 mm) and level out using the flat side of a notched trowel. Move the notched side of the trowel over the coat to "comb", place the cladding material on the adhesive coat and push gently to fix. Use rubber hammer for proper fixation of the cladding material. Fixation of cladding material is complete 10 minutes after placing. The open working time is 20 minutes under normal temperature and humidity conditions (temperature: 20°C ± 2°C; humidity: 65-70%).

Storage conditions and durations: Product in a dry and clean place, can be stored for 12 months by stacking a maximum of 10 pieces on wooden or similar pallets, provided they do not touch the floor.

Warnings: “Fortis Group” LLC is not responsible for any problems that may occur during use outside of these instructions.